Information on System Installation & Operating Instructions

For tub users needing assistance with their systems, questions regarding installation and/or operations should be directed to the distributor, dealer or location of where the tub system was purchased for support. Tub Manufacturers, Installers, or Distributors needing copies these manuals should contact Customer Care or their Sales Representative.

Important Safety Instructions

PLEASE READ CAREFULLY PRIOR TO
Troubleshooting and Servicing any Electrical Equipment

Definitions

WARNING - May cause serious injuries or death.
CAUTION - May cause property damage.

When installing and using Electrical Equipment, basic safety precautions should always be followed, including:

WARNING - HIGH VOLTAGE CAN SERIOUSLY INJURE OR KILL! SERVICE OF ELECTRICAL EQUIPMENT MUST ONLY BE DONE FROM EXPERIENCED TECHNICIANS.

WARNING - Use and follow all instructions along with any instructions that have been provided.

WARNING - DO NOT remove the protective covers from any electrical enclosures, or attempt to service any related electrical device. There are no user-serviceable parts in any of the modules, and doing so will void the warranty and may lead to failure that may lead to injury to persons or property.

WARNING - Risk of electric shock. Before working with any electrical connections, make certain that the Main Power breaker from the house breaker box has been turned off.

The system may have more than one circuit. Due to the danger of electrical shock, be certain that all power disconnects are located and turned off prior to servicing. Precautions must be taken whenever working with breaker boxes, GFCI’s, or service disconnects.

WARNING - All electrical work must be performed by a qualified licensed electrician and must conform to all national, state, and local codes.

Grounding and Bonding: Powered components may include a ground wire (3-prong plugs and sockets). An additional bonding wire must connect all metal components under the tub. A bonding lug is provided on each part that needs bonding for this use. A minimum of #8 solid bare copper must be used for bonding, per UL 1795 requirements.

NOTE: If a problem is ultimately found with a module of the system, it must be replaced. There are no user serviceable parts in any of the modules and attempting to repair or modify them may lead to injury to persons or property and will void the warranty.

Water leaks from any piping and plumbing connections can result in water and property damage. The bath system must be thoroughly inspected and tested for proper operation, and must be completely leak-free.

Use and follow these instructions along with all instructions that have been provided in order to fully enjoy the bathtub safely.

Tub Manufacturers needing copies of any product installation, troubleshooting, and/or operating manuals should contact Customer Care or their Sales Representative.